Technical Information

All heat outputs are shown at 50°CΔt, in compliance with BSEN442 Specification for Radiators and Convectors. To convert to 60°CΔt, multiply heat output by conversion factor 1.268 (approximate figure).
Note: to convert heat outputs from btu/hr to watts multiply by 0.293

Jumel products must be installed in accordance with BS5449, BS7671 to be guaranteed for a minimum period of 12 months from the date of despatch.

All rails are pressure tested to 100 p.s.i (6.9 bar) air immersed in water.

All models are fitted with 2 x 1/2" BSP F.I. connections. A manual bleed air vent is fitted to all hot water / dual fuel models. Auto air vents are available on request.

Heating Options

Jumel towel rails are available in the following heating options, except where indicated:

Heating Only Electric Only Dual Energy

Heating Only

Connection to a central heating or hot water circuit

Electric Only

Thermal transfer fluid filled, heated by thermostatic electric immersion heater fitted at the bottom of the rail

Dual Energy

Connected to the central heating with adequate isolation & fitted with electric element for use in summer months.

Bathroom Zones

Click on one of the images below to view the bathroom zones in accordance with BS7671:2001.


End View
Plan View

IMPORTANT: In Zone 1, element must be protected by a 30m R.C.D. (Residual Current Device). The electrical connection to the power supply for these elements must be in Zones 2/3 of the bathroom in compliance with BS7671:2001 - I.E.E. Wiring Regulations.

NOTE: It is recommended that NO electric or dual fuel towel rails are installed with the shower cubicles.